Dongguan City Mingyangda Energy Limited
Main products:Battery,Charger,Motor,Controller
Contact Us
  • Contact Person : Ms. Julia G-Power
  • Company Name : Dongguan City Mingyangda Energy Limited
  • Tel : 0086-0769-85373696
  • Fax : 0086-0769-85373969
  • Address : Guangdong,Dongguan,Hengzeng Road,Xin'an District,Chang'an Town
  • Country/Region : China
  • Zip : 523882

48v exide ups batteries for LiFePO4 battery manufacturer

48v exide ups batteries for LiFePO4 battery manufacturer
Product Detailed
48v exide ups batteries for LiFePO4 battery manufacturerany capacity are available broad-spectrum cabinet style BMS & circuit

48v exide ups batteries for LiFePO4 battery manufacturer (48v 400ah)

Item No.VoltageCapacityBattery typeLiFespanBMS

Working current





 with CANBUS

50~200A are availableW750*L800*H1600<275kg

 without CANBUS


a. Extremely safe and stable chemistry: BMS built inside to balance and protect the battery(CANBUS function is available)

b. Long life-cycle: Can be circularly used, more than 2000 times recycles, 8 times of Lead acid battery.

c. Lighter weight, with the best power-to-weight ratio: 1/3 of Lead acid battery weight.

d. Good performance at high temperature and high temperature resistance

e. Low self-discharge rate, less than 3% monthly.

f. No memory effects and highly efficient charge.

g. Environment friendly: Clean and Green energy poses no pollution on our environment.


a. Large voltage and capacity, 200A working current is available.

b. Cabinet design, battery+BMS+large current circuit pretection system+cooling system are included.

c. Broad-spectrum, such as telecom tower,solar system and any other emergency device.

d. Supporting CAN-BUS function, battery cells, BMS and Chargers are communicable.

e. With a LCD display,can display parameters of battery, temperature, SOC value, etc.

Battery Performance

1.Electrical characteristics

NO.ItemRequirementsTest Method
1DischargerateperformanceDischarge Capacity/Nominal capacity×100%A) 0.3C5A ≥100%B) 1.5C5A ≥90%

a)Standard charge at 0.3C5A under the condition

of normal atmospheric pressure and the

environmental temperature of 20°C±5°C

and45%~80% RH, discharge at 1I3/4.5I3(A)to

2.0V or the cut-off voltage which is specified in

the technical document of the company.b)the capacity(AH)=the discharge time*discharge

current,and then is described the percentage of

the nominal capacity(Charge/discharge cycle can

be conducted for 3times before meeting the

Standards(the samebelow).

2High-lowTemperatureDischargeperformanceDischarge Capacity/Nominal capacity×100%A) 55 °C ≥95%B) -20°C ≥55%

After Standard charging. Then store it at the

constant temperature of 55±2°C for 5h(of -20±2°C for 20h),and discharge at 0.3C5A

to 2.0V or the cut-off voltage which is specified

in the technical document of the company,the

capacity(AH)=the dischargetime*discharge current,

and then is described the percentage of the

nominal capacity.

3NormalStorage/HighTemperatureStorageResidual Capacity≥Nominalcapacity*80%Recoverable capacity≥Nominal capacity*90%

Store for 28 days(Store for 7 days at the constant

temperature of 55±2 °C)after standard charge,

then measure final status and residual capacity

at 0.3 C5A to 2.0V or the cut-off voltage which is

specified in the technical document of thecompany;After charge/discharge(0.3C5A/0.3C5A)cycle can

be conducted for 3 times,recoverable capacity

will be tested.

4StoragePerformancerecoverablecapacity ≥nominalcapacity *95%

Standard charge and then rest for 1H,then

discharge for 2H at0.3C5A,storge for 90 days at

20°C±5°C,After standard charge,then discharge

at 0.3C5A,(Charge/dischargecycle can be conducted

for 5 times before meeting the Standards

(the same below)

5Cycle LifeDischarge Capacity≥Nominal capacity*80%

Conduct 0.3C5A/0.3C5A cycle for 2000 times.The

discharge capacity shall be measured after 2000 cycles.

2.Safety Performance

NO.ItemRequirementsTest Method
1Over chargeNo fire,no explosionAfter standard charging,then Charge at 3C5A to 10.0V
2Over dischargeNo fire,no explosion

After standard charging,discharge 0.3C5A to 0V

at 20°C±5°C


Short Circuit

at Room Temperature

No fire,no explosion

After standard charging, keep the battery into a

ventilation cabinet and short-circuit the positive and

negative terminals directly (general resistance shall

be less than or equal to 5mΩ) for 10 minutes


No fire,no explosionno leakage

After standard charging, then let it self fall off from

a height of 1.5m(the lowest height)to a rigid wooden

board with the thickness of 20mm. The drop is

implemented one time for every face.

5Hot OvenNo fire,no explosion

After standard charging. Keep the battery in the box

with constant temperature of 85°C±2 °C and

remained for 2hours at this temperature.

6CrushNo fire,no explosion

After standard charging, keep the battery

on the bracket1. Extrusion direction:Perpendicular to the direction

of maintaining pressure on the battery plates.2. Extrusion headdress product:≥20cm3. Extrusion degree: Until the battery shell ruptured

or internal short circuit (battery voltage becomes 0V)

7NeedlepunctureperformanceNo fire,no explosion

After standard charging, keep the battery on the

bracket,penetrate through it with a 3mm~8mm

diameter nail near the center of its biggest surface

at the rate of 10mm/s-40mm/s.

Battery performance graph

Why  choose G-Power Battery?

G-Power is a leading hi-tech enterprise combining technical research, development, manufacture and marketing. Specializes in researching, designing and manufacturing lithium ion batteries,LiFePO4 batteries,etc.

Customer Feedback

Your Cabinet storage batteries are very good,Let's continue discussions and see what we can work out .(Ralf from Germany)

Order information

Sample is avaliable

Trade term: FOB Shenzhen or Guangzhou; EXW, CIF,DDU and DDP are available.

Delivery time: 15 working days for sample order, 25 working days for mass order.

Packing info is as below:

Cabinet battery each facets are protected by foam and plastic wrap,packing in one wooden case,then put on a pallet.

one pallet and one wooden case pack one cabinet battery only.


2 years since the date of purchase

Warranty term

1. Under the terms of this warranty, if the product have a failure occurs under normal usage within warranty period, G-Power will provide new products based on the proof-documents.

2. If Failure or damage due to incorrect operation, wire connection, or anything other do not follow our instuction, G-Power will provide paid maintance within warranty period.

More information on our products, pls do not hesitate to inquiry now!

48v exide ups batteries for LiFePO4 battery manufacturer

Copyright Notice @ 2008-2012 ECVERY Limited and/or its subsidiaries and licensors. All rights reserved.